What problems will a small inclination angle of shoe & garment sorting chute cause to package slidin
When the inclination angle of the shoe and clothing sorting chute is insufficient, the downward force of gravity along the chute is not enough to overcome the static friction between the package and the board surface. Especially for shoe and clothing categories including soft cloth bags, non-woven bags, pleated express bags, and clothing packages with thread ends, the following series of problems
When the inclination angle of the shoe and clothing sorting chute is insufficient, the downward force of gravity along the chute is not enough to overcome the static friction between the package and the board surface. Especially for shoe and clothing categories including soft cloth bags, non-woven bags, pleated express bags, and clothing packages with thread ends, the following series of problems are more likely to occur:
1. The package cannot be started, resulting in a stuck card package
The package stops moving after falling into the bottom of the chute and cannot slide down on its own. The bottom of soft packaging bags is prone to wrinkling and hanging threads, and the frictional resistance is significantly higher than that of hard shoe boxes, making them a high-risk category for card bags.
2. Continuous blockage of packages causes the sorting line to shut down
After the package is stuck, the subsequent packages that continue to fall in stack at the entrance, causing blockages and paralysis of the grid opening, requiring manual intervention to clean and reduce sorting efficiency.
3. Poor adaptability to working conditions, failure occurs with slight environmental changes
Dust on the surface of the chute, accumulation of fiber ends, humid environment, and slight wear on the lining will further increase friction, causing packages that could barely slide to get stuck. During low temperatures in winter, the polymer lining becomes harder, the friction characteristics change, and the probability of getting stuck further increases.
4. Intermittent sliding
The package starts and stops, the sliding speed is unstable, and the front and rear packages are prone to stacking and squeezing each other in the chute. The timing of the goods arriving at the exit is chaotic, which affects the subsequent packaging operation.
5. The package is partially stuck and jammed diagonally
Soft bags, hang tags, and clothing thread ends are easily hooked on the seams and corners of the groove; When the inclination angle is insufficient, the package does not have enough downward thrust to break free and gets stuck at the corner of the side and bottom plates.
6. The adhesion and stacking of goods form a "bridging" phenomenon
Multiple lightweight clothing bags are stacked and supported by each other, forming an overhead bridge. The passage is blocked, making it difficult for subsequent goods to pass through and making cleaning even more challenging.
7. Small fault-tolerant space for on-site debugging
Once the lining wears and accumulates dirt, the performance deteriorates rapidly; It is difficult to rely solely on on-site fine-tuning to solve the problem in the later stage. Often, it is necessary to modify the angle of the bracket to raise the chute, which requires a large amount of renovation work.
18151596636
Home
Product
Wechat
Telephone